Skip to content

选择机架

After installing firmware you need to select the vehicle type and specific frame configuration that best matches your vehicle frame. This applies appropriate default parameter values for the selected frame, such as the vehicle type, number of motors, relative motor position, and so on.

Info

Choose the frame that matches your vehicle brand and model if one exists, and otherwise select the closest "Generic" frame option matching your vehicle.

Set the Frame

To set the airframe:

  1. Start QGroundControl and connect the vehicle.
  2. Select "Q" icon > Vehicle Setup > Airframe (sidebar) to open Airframe Setup.
  3. Select the broad vehicle group/type that matches your airframe and then use the dropdown within the group to choose the airframe that best matches your vehicle.

Selecting generic hexarotor X frame in QGroundControl

The example above shows Generic Hexarotor X geometry selected from the Hexarotor X group.

  1. Click Apply and Restart. Click Apply in the following prompt to save the settings and restart the vehicle.

Next Steps

Actuator Configuration & Testing shows how to set the precise geometry of the vehicle motors and actuators, and their mapping to flight controller outputs. After mapping actuators to outputs you should perform ESC Calibration if using PWM or OneShot ESCs.

Further Information